Error B200 indicates that the printhead's has a temperature or voltage that isn't normal. This could mean that the printer is damaged. However, before you do, look at these possible solutions:
Solution 1 :
- Unplug your printer's power cord.
- Wait 1 hour.
- Make sure you connect the power cable
Solution 2 :
- Clean and inspect the Contact pins on the head of the unit that is used for carriage
- Verify the connection of the cable, particularly the carriage FFC
Solution 3 :
- Switch off the power
- Unlock the panel.
- Power on.
- Allow the print carriage to move toward the left.
- Let it continue over the half way mark
- When the print carriage is at left-hand side, close the cover.
- Turn off the printer.
Solution 4:
- Remove the power plug.
- Print the document.
- The entire print head's mechanism toward the center
- If the printer is still running Plug in the power and switch it on.
- If the printhead continues to move and is moving towards the left, shut the cover.
- Make sure to wait until it boots up.
Solution 4a:
- Remove all ink cartridges
- Lift the bar of grey by the point at which the ink flows
- The print head was left to the right of the print head for all time, while it was turned off.
Solution 4b:
- Make sure to clean the head primers and cleaners themselves off the printer (the very right)
Solution 4c:
- Shut off the printer
- Uncover the cover
- The printer should be turned on.
- Allow the printing carriages to start going to your left, then let it continue to move until it is at least half the distance.
- When the print carriage is at its the left side (but after having crossed halfway) close the cover.
- Make sure the Printer is turned on. Canon pixma IP8750 Error Code b200 This means that the printhead's has a temperature or voltage that indicates that the printhead's voltage or temperature is not normal. This could mean that the printer is damaged . However, before you do, look at these possible solutions: Canon Pixma IP8750 Error Code B200
Solution 1: - Unplug this power supply cable to the printer.
- Wait 1 hour.
- The power cord is connected.
Solution 2:
- Check and clean the Head contact pins condition of the unit that is used for carriage
- Make sure the cable is connected, especially the carriage FFC
Solution 3 :
- Switch off the power
- Unlock the panel.
- Power on.
- The print carriage will move towards the left.
- Let it continue over the half way mark
- When the print carriage has reached left-hand side of the cover.
- Make sure the printer is turned off.
Solution 4 :
- Remove the power plug.
- Print the document.
- The entire print head's mechanics toward the center
- If the printer is still running connect the power source and turn it on.
- When the printhead is still moving and is heading to the LEFT put the cover back in place.
- It will take a while to boot up.
Solution 4a:
- Get rid of all the ink cartridges
- Lift the grey bar to where the ink flows
- The print head was left to the right of the print head for all even though the machine was turned off.
Solution 4b :
- Clean the primers/cleaners on the plastic heads in the print head (the leftmost)
Solution 4c :
- Switch off the printer
- Lift the cover
- Switch on the printer
- Allow the your print carriage to begin going to your left, then let it continue to move until it is about half-way.
- When the print carriage is at its the left side (but after it has crossed the entire length) close the cover.
- Make sure the printer is turned on.
